Performing Standard Water Heater Maintenance

Standard water heater maintenance is needed to ensure that unit remains in peak operating condition to reduce the likelihood of problems. One of the basic types of maintenance that is preformed on a typical water heater is a flush. Flushing a water heater removes any sediment that has collected over time.

The first step to flushing a water heater is to turn of the appliance. This is done for an gas unit when the shut-off valve for the gas is closed. You can turn off an electrical unit from your homes circuit panel. If you are not sure about how to proceed, then contact a local plumber to complete the job.

When the unit has been turned off, attach one end of a garden hose to the drain valve. This valve can be found at the bottom of the unit. Run the other end of the hose outside in your yard or into a drain that is nearby. You will then need to close the shut-off valve for the water line feeding the hot water heater.

Turn the handle of the drain valve counterclockwise to begin draining water. You should then see water begin to flow out of the garden hose. This process will take a few minutes to complete. When all of the water is drained, you can then disconnect the hose from the drain valve.

Open the the shut-off valve for the water to begin filling the hot water heater. When water begins to fill the water heater, you can then turn on the breaker at the circuit panel or open the shut-of valve for the gas. More info: water heater maintenance Northbrook

Comments are closed.